Outdoor Guardians Basecamp — Campsite Alarm Kit
A heads-up around camp. Position four wireless sensors around your campsite and receive movement alerts on one handheld receiver.
- 1 receiver + 4 rechargeable sensors
- RADAR, PIR and MIX detection modes
- 3 m / 6 m / 9 m detection settings
- USB-C charging
- Adjustable alarm tones and volume
- Hard-shell storage case included
Free shipping over $29
2-year warranty
Lifetime support
Outdoor Guardians Basecamp — Campsite Alarm Kit
Know when someone's near. Even while you sleep.
Basecamp pairs four wireless motion sensors with one handheld receiver. Place the sensors around your tent, vehicle or gear. When movement is detected, the receiver alerts you with sound or vibration and shows which sensor was triggered.
No Wi-Fi, no cell signal, no app. Just switch on and set up your perimeter.
3 modes
Radar, PIR or dual-tech detection
9 m · 120°
Adjustable detection zone (30 ft)
Up to 800 m
Sensor-to-receiver link in open areas (2,600 ft)
IP67
Waterproof sensors and USB-C port
Enjoy the outdoors. Keep an eye on camp.
A night under the stars should feel relaxing. Basecamp keeps watch so you don't have to.
While you sleep
Get alerted before someone reaches your tent, not after.
Gear left outside
Protect chairs, coolers, bikes and anything else that stays outside overnight.
Wildlife nearby
Know when animals wander close to camp in remote or wooded areas.
Three detection modes. One tap to switch.
RADAR detects any moving object with high sensitivity and wide coverage. Best for open ground.
PIR triggers only on moving heat sources such as people and animals. Ideal around trees and plants that sway in the wind.
MIX alarms only when radar and infrared both confirm movement, for far fewer false alarms in wind and rain.
Double-click the settings button to change modes. Single-click to set the range: 3 m, 6 m or 9 m (10, 20 or 30 ft).
Smarter than a basic motion alarm.
Most campsite alarms rely on a single infrared sensor. Basecamp adds microwave radar, so you can choose the right detection for each spot.
Outdoor Guardians Basecamp
- Three detection modes, switch any time
- Dual-tech MIX mode resists interference
- Fewer false alarms in wind and rain
- Up to 800 m range to the receiver
Typical PIR-only alarm
- One fixed mode, no adjustment
- Easily affected by surroundings
- Prone to false alarms in wind and rain
- Short wireless range
Alerts you can hear, or feel.
The receiver works on its own long-range radio link, up to 600–800 m (2,000–2,600 ft) in open areas. No network required.
- Know where: the screen shows which sensor was triggered and when.
- Up to 20 sensors: pair as many as you need and see how many are online.
- Alarm log: review recent alerts in the morning.
- Your choice of alert: several ringtones or silent vibration, with adjustable volume.
4-step setup
The kit includes four sensors, enough to cover every side of your tent or vehicle.
01 · Charge
Fully charge the sensors and receiver via USB-C, in about one hour.
02 · Power on
Long-press the power button on each sensor, then switch on the receiver.
03 · Place
Position sensors at least 3 m (10 ft) apart, facing outward, on a tripod, stake or flat surface.
04 · Set & test
Pick a mode and range for each spot, check every sensor shows online, then walk-test.
Built for the weather. Made to last the trip.
Rain, dew or a dusty trail, the sensors are made to stay outside all night.
IP67 waterproof
Sealed housing and a waterproof USB-C port keep the sensors working in rain and snow.
Up to 800 hours standby
Low-power design means one charge covers a whole trip. A full recharge takes about an hour.
Light to carry. Easy to mount.
Each sensor weighs 70 g (2.5 oz). Four sensors plus the receiver come to about 400 g (14 oz).
1/4-inch thread
Mount sensors on a tripod, light stand or suction mount.
Belt clip
The receiver's back clip keeps alerts within reach.
Compact & portable storage.
The receiver and all four sensors pack into the included hard-shell case. Toss it in your pack or glovebox and it's ready for the next trip.
19 × 19 × 6 cm (7.5 × 7.5 × 2.4 in).
Dimensions & specifications
| Detection technology | Microwave radar + passive infrared (PIR) |
|---|---|
| Detection modes | RADAR / PIR / MIX (dual-tech) |
| Detection range | 1–9 m (3–30 ft), presets of 3 / 6 / 9 m |
| Detection angle | 120° |
| Wireless range | 600–800 m (2,000–2,600 ft) in open areas; no network required |
| Sensors per receiver | Up to 20 |
| Alerts | Multiple ringtones, vibration, adjustable volume; sensor ID and alarm log on screen |
| Waterproof rating | IP67 (sensors) |
| Battery | 800 mAh (sensor) / 1200 mAh (receiver) |
| Standby time | Up to 800 hours |
| Charging | USB-C, 5 V ⎓ 1 A, about 1 hour to full |
| Size | Sensor 4.5 × 3 × 5 cm + 4 cm antenna / Receiver 7 × 12 × 2.5 cm |
| Weight | Sensor 70 g (2.5 oz) / Receiver 130 g (4.6 oz) |
| Mounting | 1/4-inch thread (sensor) / belt clip (receiver) |
| Warranty | 2-year warranty |
Wireless range is measured in open, unobstructed areas. Trees, terrain and vehicles will reduce it.
Everything you need to get started.
- 1 handheld receiver with belt clip
- 4 dual-tech motion sensors
- 1 hard-shell storage case
Add more sensors later, up to 20 per receiver.
Get the most reliable coverage.
- Don't point sensors at large metal objects, spinning fans or metal pipes.
- Keep sensors away from large antennas and power equipment.
- Place multiple sensors at least 3 m (10 ft) apart.
- Avoid pointing two sensor antennas directly at each other.
- In windy spots with moving branches, switch to PIR or MIX mode.
Frequently asked questions
Does it need Wi-Fi, cell signal or an app?
No. The sensors talk directly to the handheld receiver over their own radio link, so it works in remote areas with no coverage.
Which mode should I use?
Use RADAR in open areas for maximum sensitivity, PIR around trees and bushes that move in the wind, and MIX in bad weather or busy surroundings for the fewest false alarms.
How many sensors can I connect?
One receiver supports up to 20 sensors. The screen shows how many are online and which one triggered an alarm.
Can I use it without waking other campers?
Yes. Choose vibration-only or lower the volume. You can also pick from several ringtones.
Can I leave the sensors out in the rain?
Yes. Sensors are rated IP67 and have a waterproof USB-C port. Dry the port before charging.
How long does the battery last?
Up to 800 hours on standby, enough for most trips without recharging. A full charge takes about one hour over USB-C.
Can I use it at home or on a vehicle?
Yes. Use it around RVs, driveways, sheds, boats or worksites. The 1/4-inch thread fits tripods, light stands and suction mounts.
Does it guarantee campsite security?
Basecamp provides motion alerts to support your awareness. It cannot prevent an intrusion or guarantee that every movement will be detected. Walk-test each sensor after setup.
What warranty does it come with?
Basecamp is covered by a 2-year warranty, with lifetime support from the CAMPERIG team.